How to distribute the drainage of the rubber track?

The synthetic running track of the stadium has a large area, and the rainwater from the surrounding auditorium also flows into the venue. The venue must be used as soon as possible after the rain. The IAAF stipulates: "When the track and field ground is completely submerged, drain water for 20 minutes. Here The water depth of the ground area at any location shall not exceed the depth of the ground structure of the track and field".

Site drainage can be a combination of surface runoff drainage and underground infiltration. If only ground runoff is used for drainage, the site is required to be flat and the flooding slope is very uniform, which is difficult for large-area football fields and field games. It is impossible to discharge by water seepage alone, because the water seepage capacity of the site is related to the site structure itself. Even if the water seepage is good, its water seepage capacity will become worse and worse as the service life increases. In addition, the water seepage capacity of the turf football field should not be too strong, because too much water and fertilizer loss will cause poor turf growth. A more appropriate drainage method is that the seepage rate is lower than the surface runoff rate. Therefore, the method of "draining percolation combined with drainage as the main" method is generally adopted.

Divide the entire stadium rubber tartan track into three drainage areas

1. The drainage area drains the rainwater above the stands, and mainly takes the surface runoff method to drain the surface water into the drainage ditch.

2. The drainage area is the race track itself and the semicircle field at the north and south ends. There are two drainage methods in this area. When the athletic track is a slag athletic track, the drainage can be "drained and combined"; when the athletic track is a rubber tartan track, runoff drainage must be used to drain ground water into the inner side of the athletic track. Drainage ditch (see the "site structure" section for construction practices).

3. The drainage area is the area within the racetrack and the field, including the football field and its buffer zone. Generally, the method of "drainage and seepage combined" is adopted.

Comments

Standard Basketball Court Size

1. The playing basketball court is 28 meters long and 15 meters wide. The ratio of long money: 28:15. The area of the competition area is 28*15=420 m2. 2. Line: The width is 0.05 meters (5 cm). Boundary: The court boundary is at least 2 meters away from spectators, billboards or any other obstacles. The boundary on the long side of the court is called the sideline, and the boundary on the short side is called the endline. 3. Free throw line, restricted area and penalty area: the area of the three-second zone = (3.6+6)*5.8/2=27.84m2 1. The free throw line should be parallel to the end line, and its outer edge is 5.80 meters away from the inner edge of the end line; this line is 3.60 meters long. Its midpoint must fall on the imaginary line connecting the midpoints of the two end lines. 2. The ground area formed by drawing two lines from both ends of the free throw line to 3 meters from the midpoint of the end line (both measured from the outer edge)...

what is the standard tennis court size ?

The "Rules of Tennis Competition" promulgated by the International Tennis Federation and the National Sports Commission stipulate that the area of a standard tennis court shall not be less than 36.6 meters (north-south length) × 18.3 (east-west width) meters = 669.78 m2, which is also a standard tennis court. The net size of the net around the site or the inner wall of the indoor building. Within this area, the standard size of the effective doubles field is: 23.77 meters (length) × 10.98 meters (width) = 260.9 m2, There should be a margin of not less than 6.40 meters behind each end line, and a margin of flow of not less than 3.66 meters beyond each side line. Install net posts on the court, measure the center of the two posts, the distance between the posts is 12.80 meters, and the top of the net post is 0.914 meters from the ground. If it is two or more parallel tennis courts built together. The distance between the sides of adjacent venues is not less than 4.0 meters. ...

Why does PVC floor warp?

Many consumers may experience warping when using PVC flooring. When the cardboard is warped, consumers can determine that this is a flooring quality problem, and exactly what causes the PVC flooring to warp. 1. because the poor quality, it will cause warpage problems. The structural stability of PVC floor is poor, and it is easy to shrink or expand at the alternating temperature of cold and heat, so it is easy to warp. The PVC floor production standard of the regular manufacturer, the floor quality is guaranteed, durable, and can reduce the chance of warping. 2. Architectural attachments can also lead to floor edges. PVC floor surfacing accessories are often used in latex, double-sided tape and pit knife glue. High-quality glue can make the floor and the ground stick together, and it is also very waterproof. If the glue is not good, it is easy to cause the floor to be weak and easy to bend. Of course, construction quality should not be ignored. Specialized construction personnel ...

fsgrk

Search This Blog